RAINBOW BUTTERFLIES CARD 4

The fourth card using the new Rainbow Butterflies Digikit

You will need a graphics programme such as CAP2 or MCS to make this card.

This card uses Rainbow butterflies set 4

1:   Create a black square in your graphics programme approx. 13 cm x 13 cm.

2:   Import the textured paper, re-size and position it over the black square leaving a small border.

3:   Group and save to the side bar (if using CAP2).

4:   Import the swirl paper and punch a circle from the centre...approx. 8.5 cm diameter.

5:   Create another black square and punch a circle from this. Position the swirl circle over the black, re-

      sizing so there is a small border.

6:   Import and re-size the button and copy so there are 4. Position these in the corners of the card.

7:   Import the butterfly, re-size and position in the centre of the swirl circle.

8:   Remove the butterfly and then print both card and butterfly on to good quality card.

9:   Cut the butterfly out, removing the antennae.

10: Use a Versmark pen and a glittery embossing powder on the buttons and the butterfly.

11: Glue the body of the butterfly to the centre of the card, adding some artificial flower stamens for the

      antennae.

12: Glue black gemstones or pearls around the circle border if wished.