Sunday, 3 February 2013


Card 9 using the new Rainbow Butterflies Digikit.

You will need a graphics programme such as CAP2 or MCS to make this card.

This card uses Rainbow Butterflies set 5.

1:   Create a dark blue / purple square in your graphics programme approx. 14 cm x 14 cm.
2:   Import the embossed paper, re-size and position over the blue paper leaving a small border.
3:   Import the swirling butterflies paper re-size to fit exactly over the embossed paper.
4:   Crop the patterned paper to 2 cm in from the left side of the paper. Repeat, cropping to the right side
      of the paper.  
5:   Position these borders over each side of the embossed paper.
6:   Import the textured paper and re-size to approx. 3 cm square. Import the button and position in the
      of the square and group.
7:   Copy and paste to make 3, rotate by 45 degrees and position them down the centre of the middle
      panel, re-sizing to make them fit if necessary.
8:   Import the butterfly, re-size and copy and paste to make 4. Rotate 2 butterflies approx 20 degrees to 
      left and the other 2 to the right. Position as illustrated.
9:   'Deconstruct' the card so the 3 central diamond are separate from the card design. Print all on to
      good quality card.
10: Use a Versamark pad to ink the 3 diamonds and emboss with a glitter embossing powder.
11: Fix them with dssp down the centre of the card design. Add peel-off borders and more glitter if wished.

No comments:

Post a Comment

Thank you for your comments, they are greatly appreciated.